No Products in the Cart
Professional DIY Solutions Backed by 20 Years of Field Work
The following are some of the most common issues playground operators and maintenance personnel face. At Trassig, we have developed DIY solutions to each one of them backed by 20 years of field work. When you purchase any of the solutions below, you are paired with an actual installer that will guide you throughout the repair process.
This happens when UV rays degrade the polyurethane binders that hold the granules in your poured in place rubber surface together. The granulation can happen as early as a couple years after the install and will depend on how much sun the surface gets. If you ignore the granulation, your wear layer will get thinner until cracks appear and the system will fail eventually exposing the base layer.
A coat of this product will seep into the wear layer and bind the granules again extending the shelf life of your surface. The rebinder is applied using a paint roller.
Generally, as a result of not rebinding, or in high traffic areas, or simply an act of vandalism, holes present tripping hazard and also cause your surface to fail ADA tests.
Our PIP repair kits come in different sizes designed to fill different size holes. All the guesswork is taken out of the mixing proportions. Simply mix everything we send you, prime the area, and trowel.
Cracks are one of the first symptoms of thinning of the wear layer of the poured in place rubber system. They are sometimes difficult to fix since they require to be enlarged and then filled with a patch kit. Sometimes, that's not feasible.
This allows you to squeeze the content of the bottle right into the crack or the seam without enlarging it.
Unbeknown to most operators, running tracks can be fixed. You do not have to recoat or redo the entire track.
These are designed to fix most running tracks. Just prime and mix the patch we send you.
Damage to playground decking can create safety hazards and require professional repair solutions.
Our specialized deck repair kits provide everything needed to restore damaged playground decking to safe, functional condition.
A very common problem in tiles that are not installed and glued to hard surface such as concrete or asphalt. The tiles tend to migrate, causing tripping hazards and ADA issues.
Our rubber tile gap repair kits are designed specifically for this problem.
This happens when the underlying substrate is displaced, usually because of drainage issues.
Use our repair kits that are specifically formulated for these situations. A base layer kit followed by a wear layer kit installed in the same area will never move.
For the same reason PIP sinks, turf can sink due to drainage issues.
Synthetic turf repair kits fill the underlying problems and allow you to reseam the turf layer.
Damaged bonded rubber in your playground or walking path can cause tripping hazards and ADA issues.
These come in four sizes with the right binder to mix and trowel onsite.
Gaps forming at the perimeter of poured in place surfaces can create entry points for water and debris, leading to further damage.
Our specialized repair kits seal perimeter gaps effectively, preventing water intrusion and extending surface life.
The new ASTM codes call for regular sanitizing of playground surfaces which can be a tedious task.
It's basically a dispenser with a cartridge that can be hooked up to a garden hose. Our sanitizing agent kills 99.9% of bacteria and viruses commonly found on playground equipment and safety surfaces.
Typically happens in areas with freeze and thaw cycles where drainage issues freeze the water trapped between the base and wear layer, lifting the wear layer.
Use our PIP injection system to inject a specifically formulated binder into the wear layer to bond it back with the base layer. This approach will save expensive cutting and seaming of the wear layer.
